Delmhorst H4 Handle with 830-2 Coaxial 10 inch Probe Combo
|
Delmhorst H4 Handle with 830-3 Coaxial 18 inch Probe Combo
|
Used for testing standard bales. 10" Probe attaches directly to the connector on top of the meter.
|
Used for testing large bales. 18" Probe attaches directly to the connector on top of the meter.
|
Delmhorst H-4 Remote Electrode Handle. Mounts to the connector on any model.
|
Used for testing Small bales or Round bales. Attaches to H-4 Handle (required)
|
Used for testing Large bales or Round bales. Attaches to H-4 Handle (required)
|
Used for Testing Large Bales or Round bales. Attaches to H-4 Handle (required)
|
Long Pin Prod for Testing Seed and Grain in Bags or Storage. Use with G7 or any other Meter. Requires H4 Handle
|
For testing hay in the windrow. (requires H-4 handle)
|
Use with any Delmhorst Hay Meter for continuous monitoring during baling. Includes 30' power cable.
|
Use with any Delmhorst Hay Meter for continuous monitoring during baling. Includes 40' power cable.
|
30 Foot Cable, Use with any Delmhorst Bale Sensor.
|
Similar to 26-ES, the 18-ES has a 17" steel shaft. Comes with 608 insulated pins for 3 1/4" penetration. Ideal for timber, poles, and ties.
|
19-E/STC Baseboard Electrode
|
21-E Roof, Insulation, EIFS Electrode, uses #608 pins for 3.25" penetration.
|
The 496 contact pins that come with the 26-ES penetrate 1 1/8” and have insulated shanks so that only the tips are exposed.
|
Hard Cover Case fits all components shown above. Will not hold the 1986 bale sensor or the #830-3 (18") and #830-4 (36") prods.
|
MCS-4 Delmhorst Calibration Standard (16% & 22%) Hay Moisture Meters
|
Delmhorst MTC-60 Moisture Transmitter
|
